DNS

The Domain Name System is really a must for any TCIP/IP network. It is a key component of the network. That is why it is the first service we will configure.

Here we will be using Bind, ISC's DNS server. Bind has a master/slave configuration, where the master gets the DNS changes and then updates the slave. It cannot run truly redundant, in the sense that only the master is allowed to get DNS changes, if the master is down, the slave cannot be updated.

DNS Master

Network

Since looking up the DNS servers IP-address does not make any sense, we will give the DNS server a statc IP-address. Edit /etc/networking/interfaces and make the following changes.

# The primary network interface
#allow-hotplug eth0
#iface eth0 inet dhcp

auto eth0
iface eth0 inet static
        address 192.168.1.34
        network 192.168.1.0
        netmask 255.255.255.0
        broadcast 192.168.1.255
        gateway 192.168.1.1

Install BIND

apt-get install bind9

Configure BIND

Make a DDNS update key

We are going to let the DHCP server update BIND. For this we need an update key. Create it with the following command. Remember that entrophy must be available for the key to be generated, you can check available entrophy in /proc/sys/kernel/random/entropy_avail.

dnssec-keygen -a HMAC-SHA512 -b 512 -n HOST ddns-update

This will create two files with filenames equivalent to Kddns-update.+157+18646.private and Kddns-update.+157+18646.key. The latter is your public key, which will be used by the DCHP server to update BIND. Create the file /etc/bind/ddns-update.dnskey and put your key inside it.

key "ddns-update" {
        algorithm hmac-sha512;
        secret "yYFzfibvlpS33+vsngV2jF5tGkTiVSjhYoFuV0T7bnCVfFGx3Mu05SW+LakImdofkNM00LxHCLuvD1W1vSWMmA==";
};

Make BIND listen

edit /etc/bind/named.conf.options and add

listen-on { any; };

Create a new zone

/etc/bind/named.conf.kallenberg.dk

Add the new zone file to /etc/bind/named.conf.local

include "/etc/bind/named.conf.kallenberg.dk";

DNS