Differences between revisions 33 and 34
⇤ ← Revision 33 as of 2017-12-10 16:03:59 →
Size: 7589
Editor: Kristian Kallenberg
Comment:
← Revision 34 as of 2017-12-10 16:11:23 → ⇥
Size: 7040
Editor: Kristian Kallenberg
Comment:
Deletions are marked like this. Additions are marked like this.
Line 48: Line 48:
=== Make a DDNS update key ===

We are going to let the DHCP server update BIND. For this we need an update key. Create it with the following command. Remember that entrophy must be available for the key to be generated, you can check available entrophy in `/proc/sys/kernel/random/entropy_avail`.

{{{
dnssec-keygen -a HMAC-SHA512 -b 512 -n HOST ddns-update
}}}

This will create two files with filenames equivalent to `Kddns-update.+157+18646.private` and `Kddns-update.+157+18646.key`. The latter is your public key, which will be used by the DCHP server to update BIND. Create the file `/etc/bind/ddns-update.dnskey` and put your key inside it.		 === Get the DDNS update key ===

Get the key from the master and save it in `/etc/bind/ddns-update.dnskey`.
Line 72: Line 66:
        type master;         type slave;
Line 74: Line 68:
        allow-transfer { 192.168.1.35; };         allow-transfer { 192.168.1.34; };
Line 79: Line 73:
        type master;         type slave;
Line 81: Line 75:
        allow-transfer { 192.168.1.35; };         allow-transfer { 192.168.1.34; };

DNS

The Domain Name System is really a must for any TCIP/IP network. It is a key component of the network. That is why it is the first service we will configure.

Here we will be using Bind, ISC's DNS server. Bind has a master/slave configuration, where the master gets the DNS changes and then updates the slave. It cannot run truly redundant, in the sense that only the master is allowed to get DNS changes, if the master is down, the slave cannot be updated.

In this setup we use the following IP-addresses for the master and slave:

  • 192.168.1.34 master
  • 192.168.1.35 slave

DNS Master

Network

Since looking up the DNS servers IP-address does not make any sense, we will give the DNS server a statc IP-address. Edit /etc/networking/interfaces and make the following changes. 

# The primary network interface
#allow-hotplug eth0
#iface eth0 inet dhcp

auto eth0
iface eth0 inet static
        address 192.168.1.34
        network 192.168.1.0
        netmask 255.255.255.0
        broadcast 192.168.1.255
        gateway 192.168.1.1

Install BIND

apt-get install bind9

Configure BIND

Make BIND listen

edit /etc/bind/named.conf.options and add 

listen-on { any; };

Get the DDNS update key

Get the key from the master and save it in /etc/bind/ddns-update.dnskey. 

key "ddns-update" {
        algorithm hmac-sha512;
        secret "yYFzfibvlpS33+vsngV2jF5tGkTiVSjhYoFuV0T7bnCVfFGx3Mu05SW+LakImdofkNM00LxHCLuvD1W1vSWMmA==";
};

Create a new zone

/etc/bind/named.conf.kallenberg.dk 

# Key used by DHCP servers for dynamic DNS updates
include "/etc/bind/ddns-update.dnskey";

zone "kallenberg.dk" {
        type slave;
        file "/var/lib/bind/kallenberg.dk.zone";
        allow-transfer { 192.168.1.34; };
        allow-update { key "ddns-update"; };
};

zone "1.168.192.in-addr.arpa" {
        type slave;
        file "/var/lib/bind/1.168.192.zone";
        allow-transfer { 192.168.1.34; };
        allow-update { key "ddns-update"; };
};

Add the new zone file to /etc/bind/named.conf.local 

include "/etc/bind/named.conf.kallenberg.dk";

/var/lib/bind/kallenberg.dk.zone 

$ORIGIN .
$TTL 86400      ; 1 day
kallenberg.dk           IN SOA  ns01.kallenberg.dk. ns02.kallenberg.dk. (
                                20150427   ; serial
                                7200       ; refresh (2 hours)
                                300        ; retry (5 minutes)
                                604800     ; expire (1 week)
                                60         ; minimum (1 minute)
                                )
                        NS      ns01.kallenberg.dk.
                        NS      ns02.kallenberg.dk.
$ORIGIN kallenberg.dk.
$TTL 1800       ; 30 minutes

/var/lib/bind/1.168.192.zone 

$ORIGIN .
$TTL 86400      ; 1 day
1.168.192.in-addr.arpa  IN SOA  ns01.kallenberg.dk. ns02.kallenberg.dk. (
                                20150218   ; serial
                                7200       ; refresh (2 hours)
                                300        ; retry (5 minutes)
                                604800     ; expire (1 week)
                                60         ; minimum (1 minute)
                                )
                        NS      ns01.kallenberg.dk.
                        NS      ns02.kallenberg.dk.
$ORIGIN 1.168.192.in-addr.arpa.

DNS Slave

Network

Since looking up the DNS servers IP-address does not make any sense, we will give the DNS server a statc IP-address. Edit /etc/networking/interfaces and make the following changes. 

# The primary network interface
#allow-hotplug eth0
#iface eth0 inet dhcp

auto eth0
iface eth0 inet static
        address 192.168.1.35
        network 192.168.1.0
        netmask 255.255.255.0
        broadcast 192.168.1.255
        gateway 192.168.1.1

Install BIND

apt-get install bind9

Configure BIND

Make BIND listen

edit /etc/bind/named.conf.options and add 

listen-on { any; };

Make a DDNS update key

We are going to let the DHCP server update BIND. For this we need an update key. Create it with the following command. Remember that entrophy must be available for the key to be generated, you can check available entrophy in /proc/sys/kernel/random/entropy_avail. 

dnssec-keygen -a HMAC-SHA512 -b 512 -n HOST ddns-update

This will create two files with filenames equivalent to Kddns-update.+157+18646.private and Kddns-update.+157+18646.key. The latter is your public key, which will be used by the DCHP server to update BIND. Create the file /etc/bind/ddns-update.dnskey and put your key inside it. 

key "ddns-update" {
        algorithm hmac-sha512;
        secret "yYFzfibvlpS33+vsngV2jF5tGkTiVSjhYoFuV0T7bnCVfFGx3Mu05SW+LakImdofkNM00LxHCLuvD1W1vSWMmA==";
};

Create a new zone

/etc/bind/named.conf.kallenberg.dk 

# Key used by DHCP servers for dynamic DNS updates
include "/etc/bind/ddns-update.dnskey";

zone "kallenberg.dk" {
        type master;
        file "/var/lib/bind/kallenberg.dk.zone";
        allow-transfer { 192.168.1.35; };
        allow-update { key "ddns-update"; };
};

zone "1.168.192.in-addr.arpa" {
        type master;
        file "/var/lib/bind/1.168.192.zone";
        allow-transfer { 192.168.1.35; };
        allow-update { key "ddns-update"; };
};

Add the new zone file to /etc/bind/named.conf.local 

include "/etc/bind/named.conf.kallenberg.dk";

/var/lib/bind/kallenberg.dk.zone 

$ORIGIN .
$TTL 86400      ; 1 day
kallenberg.dk           IN SOA  ns01.kallenberg.dk. ns02.kallenberg.dk. (
                                20150427   ; serial
                                7200       ; refresh (2 hours)
                                300        ; retry (5 minutes)
                                604800     ; expire (1 week)
                                60         ; minimum (1 minute)
                                )
                        NS      ns01.kallenberg.dk.
                        NS      ns02.kallenberg.dk.
$ORIGIN kallenberg.dk.
$TTL 1800       ; 30 minutes

/var/lib/bind/1.168.192.zone 

$ORIGIN .
$TTL 86400      ; 1 day
1.168.192.in-addr.arpa  IN SOA  ns01.kallenberg.dk. ns02.kallenberg.dk. (
                                20150218   ; serial
                                7200       ; refresh (2 hours)
                                300        ; retry (5 minutes)
                                604800     ; expire (1 week)
                                60         ; minimum (1 minute)
                                )
                        NS      ns01.kallenberg.dk.
                        NS      ns02.kallenberg.dk.
$ORIGIN 1.168.192.in-addr.arpa.

None: DNS (last edited 2021-01-17 20:10:16 by Kristian Kallenberg)