|
Size: 2605
Comment:
|
Size: 1983
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 1: | Line 1: |
| DISCLAIMER THIS ONLY WORKS IN BUSTER INCOMPLETE DO NOT USE |
|
| Line 16: | Line 12: |
| apt-get install redis-server | apt-get install redis-server redis-sentinel |
| Line 25: | Line 21: |
| Add the IP-address for each of the servers. Each of the redis servers needs to listen on its own IP-address. Due to a bug in redis, the added IP-address will have to be in the beginning of the line, right next to `bind`. If the IP-address is added in the end of the line, then the cluster will not initialize itself, and `Waiting for the cluster to join` message wil continuously write dots. | Add the IP-address for each of the servers. Each of the redis servers needs to listen on its own IP-address. |
| Line 27: | Line 23: |
| bind 192.168.1.58 127.0.0.1 ::1 | bind 192.168.1.59 127.0.0.1 ::1 |
| Line 29: | Line 25: |
| Line 36: | Line 31: |
| Redis stores its data in memory only, hence its speed. To make sure redis does not loose its state, in case of a hardware failure, this will enable it to store the state as it changes in a file on disk. {{{ appendonly yes }}} Activate redis cluster features {{{ cluster-enabled yes cluster-config-file nodes-6379.conf cluster-node-timeout 15000 }}} Restart redis on all hosts. |
Now restart the redis master |
| Line 53: | Line 36: |
| Next we will need to configure the servers to run as a cluster | And stop the replicas |
| Line 55: | Line 38: |
| redis-cli --cluster create 192.168.1.59:6379 192.168.1.60:6379 192.168.1.61:6379 | service redis-server stop |
| Line 57: | Line 40: |
On each of the replicas, set them up af a replica of the master {{{ replicaof 192.168.1.59 }}} Start the replicas again {{{ services redis-server start }}} |
Redis
Redis is an in memory data structure storage. It will be used to share PHP-sessions between the apache servers. To guarantee a robust deployment three redis servers will be configured.
- 192.168.1.59 redis01
- 192.168.1.60 redis02
- 192.168.1.61 redis03
Software
apt-get install redis-server redis-sentinel
Configuration
Redis Server
Change the contents of the redis configuration file in /etc/redis/redis.conf.
Add the IP-address for each of the servers. Each of the redis servers needs to listen on its own IP-address.
bind 192.168.1.59 127.0.0.1 ::1
Enable redis to listen on the network, instead of only listening on the loopback device.
protected-mode no
Now restart the redis master
service redis-server restart
And stop the replicas
service redis-server stop
On each of the replicas, set them up af a replica of the master
replicaof 192.168.1.59
Start the replicas again
services redis-server start
References
https://www.haproxy.com/blog/haproxy-advanced-redis-health-check/
https://blog.usejournal.com/first-step-to-redis-cluster-7712e1c31847
https://www.willandskill.se/en/setup-a-highly-available-redis-cluster-with-sentinel-and-haproxy/
https://www.tecmint.com/setup-redis-replication-in-centos-8/
https://www.tecmint.com/setup-redis-high-availability-with-sentinel-in-centos-8/